elua on Omnima STMExpander post message

classic Classic list List threaded Threaded
1 message Options
Whee Min TAN (NYP) Whee Min TAN (NYP)
Reply | Threaded
Open this post in threaded view

elua on Omnima STMExpander post message



I’m new to elua and scripting language. I wonder anyone can advise me  on the below.


-Does Omnima STM32 Expander comes with elua pre-loaded image? If not, how do I pre-loaded the elua to start programming?

-Does Omnima STM32 Expander comes with pre-installed elua library? If yes, any additional info on how to use it?

- Is there a special file location that I need to place a elua written source programs so that to execute it even when board is powered-up? Do we have to write a batch file using Make command?

-How to burn/jtag a elua file written in notepad eg xxx.elua into the STM32 Expander? What is the command?


Thks & rgds,

Tan Whee Min | Development Engineer

Tel: 65-65500583   Fax: 65-64520400  |  [hidden email]  |  www.nyp.edu.sg



eLua-dev mailing list
[hidden email]