Hello Guys,
As you've probably seen on our repo's trunk and branches, our pos-v0.6 development is going fast and rich now. Support for the STR9 has evolved and now supports the Olimex STR-E912 board too.
Could someone give some hints on how to initialize and use what should be a simple GPIO lib, for the STR912 ? :)
These toys are getting more and more complex and I'm kind of lost on how to use a simple C API, the original ST lib, even for the basic GPIO operations.
What I need is some directions for (from C):
- Initialize the GPIO module/lib (if needed).
- Setup some ports/pins as inputs and outputs
- Read and Write values to port/pins
I'm writing a driver for an old WG128464A-YYH-V LCD, with a KS0108B controller, that will be used in an eLua application with an STR912
Thankssssss
Best
Dado
_______________________________________________
Elua-dev mailing list
[hidden email]
https://lists.berlios.de/mailman/listinfo/elua-dev
Locked
